Youth (95-125 lbs) Flak Jak IMS CLOSEOUTS
Form Flex Biceps
Peewee/Youth [Add $9.99]
New Rivet Construction (RC) IMS Padding system
(Impact Management system)
Adjustable pivoting shoulder straps
1.5" Adjustable woven elastic
1.5" Airlock buckle
Plastic Sleeved Metal Rivet Pivot point
High Density Poly Molded Plates
Our original Nitrolyte padding w/net suspended floating shoulders.
Made in The USA
Sporting events are dangerous in nature and use of this equipment can not prevent injury or death. The user assumes all risks in participating in any activity wherever or however HRP equipment is used. All equipment is sold on this condition and no company representative can waive this condition.
WARNING: Use of any fuels, chemicals, solvents, or cleaners (other than those available through HRP Sports) to clean your FLAK JAK™ Chest Protector will cause damage and void all warranties provided.
For best results first spray your FLAK JAK™ Chest Protector with clear water to remove all excess loose dirt, debris, roost, or bike parts.
For more firmly attached soil or knobby marks use a soft cotton cloth or sponge soaked with water and scrub gently.
Cleaning your FLAK JAK™ Chest Protector without rinsing or using sufficient amounts of water will quickly scratch and deteriorate the finish.
Finally rinse your FLAK JAK™ Chest Protector with clear water and hang dry. While still damp you can polish with a soft cotton cloth to remove water drops.
Contact HRP Sports at 1-800-FLAK-JAK if you need assistance or have any questions about how to properly care to your FLAK JAK™ Chest Protector.
PROPER FLAK JAK ADJUSTMENTS
For best performance from your FLAK JAK™ make sure it's adjusted to fit you perfectly.
There are 3 adjustment slots on each shoulder strap so you can fine tune both front and rear FLAK JAK™ shoulder and body panel positioning.
Simply turn your FLAK JAK™ inside out and see how the 4 attachment clips are positioned (standard setting is in the middle) in the shoulder cup.
Now either move the clip up or down in the slot provided to lighten or loosen the fit between the shoulder cap and body panel.
FORM FITTING BICEP: ONE-WAY SNAP SYSTEM
If you look under the cap piece, you will see that inside the female black cap, there is a little metal tab, this is there to secure the male part of the snap so that it doesn't come undone when riding.
To fasten the male into the cap portion, you make sure that the male snap fits under the tab and then it snaps in easy.
To unfasten the snap, you need hold your thumb and turn the male part 180 degrees away from the tab and lift. The female tab is always facing the outside of the cap.
SG 360™ Navy
Flak Tech Shins
AS1 Blue Kids Motocross Pants
Ripp Offs Economy
Share your knowledge of this product.
Be the first to write a review »
HRP Products, Inc.. All Rights Reserved.